If you are having problems with the Conversation Editor Re: Copy/Paste as Link
You need to change one of the entries in the nwtoolset.ini as shown below. Specificaly,
the entry in the ‘Conversation’ section of the ini labeled ConvLinkPasteMode. Change from
0 to 1 as shown.
The ini entry ConvLinkLinkMode also is set at 0, and I changed it to 1 also, even thougn
I’m not sure exactly what it refers to.
Before I changed these two entries, I was unable to write links into the Conversation. Actually
they did write, but did not show up (as Grey entries) in the Conversation Screen (they were there,
but didn’t show up).
I hope this helps someone, as I spent many frustrating hours trying to figure out why ‘Paste as Link’
ConvLinkPasteMode=1 // Original=0 Change to 1 //
ConvLinkLinkMode=1 // Original=0 Change to 1 //